Direct Warping Machine

  • Section beam measurements : 14" inch overall length and 17" inch flange diameter.
  • Construction: Steel frame with built-in motor. Indirect drive transmitted through v-belt ulleys to right hand stationary beam holding assembly.
  • Drive and electrical control: 4KW motor. Magnetic brakes.  Oilling device, Static eliminator and stop motion.
  • Main reed: Adjustable reed with traverse movemts.
  • Take - off speed : Up to 300 M/Min.

 

This slitting extension machine is located in front and rear of aRaschel knitting machine, which is used to slit a HDPE film and extend, then yarns are fed directly to the Raschel knitting machine. The machine aconsists mainly of : Sheet width : 1,2000mm Opening rollers
Fixed flat knives with adjustable spacing ring to give strip width of 4.0 - 7.0 mm 
Transport rollers driven by 2 steps change drive.
Winding beam devices of the selcedge yarn.
Main drive: 2 sets machine attached one unit 2.2 Kw motor
Heater: each set machine attached 5 Kw.